FSAirlines

Hi All, can anybody tell me why when I set my ADF to a freq. and then takeoff it switches back to 0100.0, and cannot be adjusted until I land......
What have I done wrong, or is it a fault, I am using PMDG beech 1900D....

I am not using PMDG but very same problem occurs if you use older versions of Rob Barendregts "Ground Handling Gauges".
I think the problem is fixed after v3.2
Maybe PMDG uses such gauge.

mau1940 wrote:Hi All, can anybody tell me why when I set my ADF to a freq. and then takeoff it switches back to 0100.0, and cannot be adjusted until I land......
What have I done wrong, or is it a fault, I am using PMDG beech 1900D....

Have no idea about 1900D, but PMDG's (and real) Boeings normaly use NAV facilities to assist IRS system to have as precise as posible positioning all the time. It switches NAV frequencies to all surrounding VORs. but I'm not sure, that this system use NDBs as normaly they provide radial only, but not distance, which is needed as well.

have you tried to search PMDG forums for this issue?

Hi Kimis, You are correct that is in the PMDG Boeings, but this is in the 1900D which has no FMC, but I put in Rob Barendregt's GroundHandling, so it must in there

Hi all, I had Rob Barendregts "Ground Handling Gauges". v 3.2, and installed v4.0, now I cant release the brakes......
Oh dear.....
So I unistalled it and going on without it.....